Back-lit switches: Difference between revisions
No edit summary |
No edit summary |
||
Line 17: | Line 17: | ||
The contact surfaces are gold-plated PCB traces, the switch contacts are small metal see-saw style springs point-welded to a center support pin that is soldered into the PCB. | The contact surfaces are gold-plated PCB traces, the switch contacts are small metal see-saw style springs point-welded to a center support pin that is soldered into the PCB. | ||
The contacts can break off from the support, giving no or intermittent conduction. It is possible to solder the contact to the support if care is taken to apply solder only to the center. | The contacts can break off from the support, giving no or intermittent conduction. It is possible to solder the contact to the support if care is taken to apply solder only to the center, or to transplant an unused contact (see example photo). | ||
Revision as of 03:52, 7 March 2022
![](http://w140.com/tekwiki/images/thumb/a/a3/Tek-pushbutton-light-on.jpg/400px-Tek-pushbutton-light-on.jpg)
![](http://w140.com/tekwiki/images/thumb/b/be/Tek-pushbutton-light-off.jpg/400px-Tek-pushbutton-light-off.jpg)
![](http://w140.com/tekwiki/images/thumb/a/a5/Tek_7k_DPDT_PCB_switch_1.jpg/400px-Tek_7k_DPDT_PCB_switch_1.jpg)
Tek introduced back-lit pushbutton switches at the end of the 1960s in the 7000 scope family.
Lamps
There is one miniature 5 V incandescent lamp per interlocking group of buttons, with clear plastic light guides reflecting the light to the backs of the transparent plastic buttons. The lamp is powered all the time. In the Off state of the switch, a small metal flap covers the un-lit button end, whereas in the On state, this flap is pushed open.
The lamps are not supplied from the standard +5 V (logic supply) rail but from a separate lamp supply rail which is not present in all mainframes (e.g. missing from 7xx3 series scopes; see modification 040-0686-01 adding this supply).
In mainframes that do supply the lamps, the lamp voltage (and therefore lamp intensity) can often be varied, e.g. through a 3-way (off/mid/high) switch in the back of the instrument. In some early 7000-series scopes like the 7503, 7504, or 7904 (non-A), this is a front panel control.
Contacts
The switch consists of a mechanical interlock with sliding plungers that is attached on top of a PCB. This plastic part is screwed to the front panel (under the printed aluminum cover plate).
The contact surfaces are gold-plated PCB traces, the switch contacts are small metal see-saw style springs point-welded to a center support pin that is soldered into the PCB.
The contacts can break off from the support, giving no or intermittent conduction. It is possible to solder the contact to the support if care is taken to apply solder only to the center, or to transplant an unused contact (see example photo).
-
-
-
-
Dual DPDT switch interior (mV / mρ mode switch from a 7S12)
-