C1001
The Tektronix C1001 is an analog video camera designed to be used with a video frame grabber card in an IBM-compatible PC and Tek waveform processing software.
The camera part was made by NEC and puts out an NTSC signal. It was later superseded by the compatible C1002.
Key Specifications
| Focal Length | 10.746 mm at 5200 A |
|---|---|
| F number at infinity | F/1.3 |
| Field of View | 7.2 cm x 9 cm and 8 cm x 10 cm |
| Pixels | 490 vertical, 384 horizontal |
| Resolution | 480 vertical, 285 horizontal |
| SNR | >47 dB |
| Video Output | 1 Vp-p composite into 75 Ω |
Parts
- 016-0248-01 mounting adapter for C1001 (or C30 camera) to 7000-series scopes except 7603
- 016-0269-03 mounting adapter for 2400 series and 465
- 016-0306-01 mounting adapter for older 400 series (485, 454 etc.)
- DX01 frame grabber board, with option 01 (DCS01 waveform processing software)
- 174-0449-00 DCS cable
Connectors
According to this posting, The camera has a 9-pin D-sub connector that takes in 12 V, around 300 mA at pins 1 (positive) and 3 (ground) and signal is on pins 4 (shield/ground) and 5 (video); there are two other pins used which bring in calibration voltages and go only to BNC and two test points.
