507

The Tektronix Type 507 was designed for the power industry for surge testing. It was introduced in 1959.

{{{manufacturer}}}
Power Industry scope 507 Produced from 1959 to 1974 Manuals Tektronix 507 Manual (PDF) W. D. Bunting, "A Reliable Spark Gap For Capacitor Bank Switching" Thomas and Hearst, "An Electronic Scheme for Measurement of Exploding Wire Energy" (All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The scope was intended to operate in an environment of strong electromagnetic fields. It does not take plug-ins. The power supply is external, like in the 517, 551, and 555.

The vertical signal path of the 507 does not contain amplifiers. It has a 5 nanosecond risetime. The input impedance of the 507 is 72 Ω. The maximum sensitivity is deliberately low, at 50 V/cm.

The input attenuator is very unusual for Tek scopes. It is a switch with ten positions in "% of signal", where each step is 10%. The deflection signal is permanently AC-coupled and, unusually, the DC blocking capacitor is after the input attenuator.

The 507 has 20 kV of post-deflection acceleration, produced by four 1X2 tubes. The lower-voltage power supplies, located in the external box, are all tube except for selenium rectifiers for some of the lower voltages.

The 507 uses the T507 CRT.

Links

Service Scope No. 18, Feb 1963: Anode-Connector Arcing in the Type 507 Oscilloscope

Pictures

507
507
507 power supply
507 power supply bottom
507 power supply
507 power supply
507 power supply
507 rear
507 right internal
507 right internal
507 top
507 bottom
507 on Cart
507 with Power Supply
507 at General Electric
Block Diagram
Sweep Trigger and Trip Pulse
Time Mark Generator
Vertical Deflection
Horizontal Amplifier
CRT Circuit
Heater Wiring
Power Supply