36,375
edits
7B53A: Difference between revisions
no edit summary
(Added link to local copy of instruction manual) |
No edit summary |
||
| Line 50: | Line 50: | ||
}} | }} | ||
{{EndSpecs}} | {{EndSpecs}} | ||
==Links== | |||
* [[Media:Tekscope 1975 V7 N5.pdf | TekScope Vol. 7 No. 5, 1975 p.15+: Dave McCullough, ''Delayed gate aids oscilloscope digital measurements'']] | |||
==Operation== | ==Operation== | ||
===Delayed Sweep Gate output === | |||
When the delayed timebase trigger source switch is set to INT (pushed in) and the internal connector P613 is in the active position, | |||
the DLY'D TRIG IN connector becomes a Delayed Sweep Gate output. | |||
This is useful e.g. to connect to a [[7D15]]'s arming inputs, or a [[7D12]]/[[M2]]'s external trigger input. | |||
See the 1975 TekScope article linked above. | |||
===Variable control=== | ===Variable control=== | ||
Through an internal jumper, the front-panel variable control (red knob) can be selected to vary either the main sweep, | Through an internal jumper, the front-panel variable control (red knob) can be selected to vary either the main sweep, | ||
the delayed sweep or the main sweep hold-off. | the delayed sweep or the main sweep hold-off. See the 1975 TekScope article linked above. | ||
See | |||
===Use as Delayed Timebase === | |||
The 7B53A only works in "triggered after delay" mode when used as a delayed timebase, unlike e.g. the [[7B92]]. | |||
===X-Y operation=== | ===X-Y operation=== | ||
The 7B53 supports X-Y mode by selecting the "Ampl" position on the Time/Div switch. | The 7B53 supports X-Y mode by selecting the "Ampl" position on the Time/Div switch. | ||
The X signal can be picked up from a vertical plug-in via the internal trigger path or applied via the "Main Trig In or Amp In" input, | The X signal can be picked up from a vertical plug-in via the internal trigger path or applied via the "Main Trig In or Amp In" input, | ||
as determined by the Trigger Source switch setting. Sensitivity on the external input is | as determined by the Trigger Source switch setting. Sensitivity on the external input is 100 mV/Div, | ||
which can be increased to | which can be increased to 10 mV/DIv by selecting the x10 magnifier, or decreased to 1 V/Div by pushing the EXT÷10 button. | ||
==Prices== | ==Prices== | ||