P6032: Difference between revisions

P6032 (view source)

Revision as of 13:11, 7 July 2015

22 bytes removed , 7 July 2015

no edit summary

Peter

Bureaucrats, Interface administrators, Suppressors, Administrators

36,230

edits

@@ Line 2: / Line 2: @@
 There is an [[EC1000]] subminiature triode in the probe body.
 Like all active probes, the P6032 requires power, and for this reason it has two connectors at the scope end of cable.
-There is a four-pin power connector and a 50-Ohm [[Connectors#GR-874|GR 874]] connector for the signal.
+There is a four-pin power connector and a 50-Ohm [[GR-874 connector]] for the signal.
 The triode has limited dynamic range, so attenuator attachments are provided that attach to the tip of the probe.
 These attenuators also reduce the loading of the probe on the probed circuit.
@@ Line 18: / Line 18: @@
 <gallery>
-Image:p6032_ext.jpg|External view of P6032 without attenuator attachment.
+File:p6032_ext.jpg|External view of P6032 without attenuator attachment.
 File:P6032-schematic.png|P6032 Schematic
-Image:p6032_int_c.jpg|Internal view of P6032  Probe tip connects directly to triode grid, which is a bare wire coming out of the top of the tube.  Clipping line runs along the body of the probe to the left of the tube socket.
+File:p6032_int_c.jpg|Internal view of P6032  Probe tip connects directly to triode grid, which is a bare wire coming out of the top of the tube.  Clipping line runs along the body of the probe to the left of the tube socket.
-Image:p6032_pwr.jpg|Internal view of power supply at end of P6032 cable.  Signal coax passes through undisturbed.
+File:p6032_pwr.jpg|Internal view of power supply at end of P6032 cable.  Signal coax passes through undisturbed.
-Image:p6032_risetime.jpg|Display on [[545|545A]] with 1S1 and P6032.  Pulse is generated by Tek [[284]] tunnel diode pulser driving into 50 ohm load, GR-BNC adaptor and then to the probe using a probe to BNC adaptor.  The 10x attenuator tip was used on the P6032.  Timebase is 200ps/div.
+File:p6032_risetime.jpg|Display on [[545|545A]] with 1S1 and P6032.  Pulse is generated by Tek [[284]] tunnel diode pulser driving into 50 ohm load, GR-BNC adaptor and then to the probe using a probe to BNC adaptor.  The 10x attenuator tip was used on the P6032.  Timebase is 200ps/div.
 </gallery>
 [[Category:50 Ohm Oscilloscope Probes]]
 [[Category:Active Oscilloscope Probes]]