PS503: Difference between revisions

PS503 (view source)

Revision as of 11:25, 19 February 2018

995 bytes added , 19 February 2018

no edit summary

Peter

Bureaucrats, Interface administrators, Suppressors, Administrators

36,375

edits

@@ Line 3: / Line 3: @@
 * [http://w140.com/smb/PS503A_SM.pdf Tektronix PS503A Manual (OCR, PDF)]
 }}
-It supplies 0 to -20 V and 0 to +20 V at 1 A (0.4 A in low power compartments) as well as +5 V at  1A. The variable supplies can be adjusted independently or can track one another.
-{{MissingSpecs}}
+It supplies 0 to -20 V and 0 to +20 V at 1 A (0.4 A in [[TM500 high-power compartments|low power compartments]]) as well as +5 V at 1 A.
+The variable supplies can be adjusted independently or can track one another, and are floating; the 5 V output is ground referenced.
+{{BeginSpecs}}
+{{SpecGroup | Variable outputs }}
+{{Spec | Output voltage   | 0 to +20 V and 0 to -20 V, 1 A }}
+{{Spec | Current limit    | <100 mA to >1 A (0.4 A if used in low power compartment) }}
+{{Spec | Ripple and noise | <3 mV<sub>p-p</sub> @ 1 A }}
+{{SpecGroup | Fixed output }}
+{{Spec | Output voltage3 | 5 V ±5%, 1 A (ground referenced) }}
+{{Spec | Current limit | Outputs 1,2: <100 mA to >1 A; Output 3: fixed 1 A }}
+{{Spec | Ripple and noise | <3 mV<sub>p-p</sub> @ 1 A }}
+{{EndSpecs}}
+==Rear interface signals==
+* +20 V output (22A)
+* −20 V output (22B)
+* ±20 V common (24A, 24B)
+(the connections below require various jumper changes in the PS503 as described in the manual)
+* Remote resistor programming (via 25A, 25B)
+* Remote voltage programming (via 25A, 25B)
+* Remote sensing (+Sense 23A, −Sense 23B)
 ==Pictures==
 <gallery>
-File:Tek ps503a.jpg|PS503A
+Tek ps503a.jpg       | PS503A
-File:Tek ps503a front.jpg|PS503A
+Tek ps503a front.jpg | PS503A
-File:Tek ps503a right.jpg|PS503A
+Tek ps503a right.jpg | PS503A
+PS503A-rear-sw.jpg   | Switch S95 in rear of PS503 (detects high power compartment)
 </gallery>
 [[Category:TM500 power supply plugins]]