31,822
edits
No edit summary |
No edit summary |
||
(2 intermediate revisions by 2 users not shown) | |||
Line 20: | Line 20: | ||
When the S-2 was first introduced, the rise-time specification was 50 ps, but that | When the S-2 was first introduced, the rise-time specification was 50 ps, but that | ||
was not achieved in practice, so the rise-time specification was revised to be 75 ps. | was not achieved in practice, so the rise-time specification was revised to be 75 ps. | ||
The interface between the GR-874 connector and the printed circuit board is described in US Patent 3,426,311. | |||
{{BeginSpecs}} | {{BeginSpecs}} | ||
Line 30: | Line 32: | ||
<gallery> | <gallery> | ||
Tek s2 front.jpg | |||
S-52 s-2 rt.jpg | [[S-52]] and S-2 give 76 ps rise-time together | |||
S2 schem1.png | schematic | |||
Tek s2 strobe side.jpg | S-2 interior, strobe board side | |||
Tek s2 amp side.jpg | S-2 interior, amplifier board side | |||
Tek s2 bridge in place.jpg | Sampling diodes in place | |||
Tek s2 input term r4.jpg | Input termination resistor | |||
Tek s2 sampler r.jpg | Sampler board, right | |||
Tek s2 sampler l.jpg | Sampler board, left | |||
Tek s2 diode removal.jpg | Diode holder slides out | |||
Tek s2 amp under.jpg | Sampler board underside | |||
Tek s2 amp removed.jpg | S-2 with amplifier board removed | |||
Tek s2 strobe under.jpg | Strobe board underside | |||
Tek s2 strobe removed.jpg | S-2 with strobe board removed | |||
Tek s-2 rise trace.jpg|S-2 pulse response | |||
</gallery> | </gallery> | ||
[[Category:7000 and 3S series sampling heads]] | [[Category:7000 and 3S series sampling heads]] |