The rightmost compartment (slot 6) can supply high-powered plugins.
The DC rails to the plugins are provided by a switch-mode PSU. The supply is not universal input voltage, the input voltage must be set with two internal jumpers. DC rails are 8 V, +26 V, and −26 V. The case has a cooling fan which is connected to the primary of the transformer.
Available options include Opt.02, Rear Inputs, and Opt.10, a set of 19-inch rackmount slides.
For option 02, six BNC connectors and a 50-pin female DD-50 D-sub connector are installed on the rear panel and pin headers soldered internally, but no internal wiring is pre-installed.
The rack-mount kit has different sides compared to the standard model. It is not possible to remove the standard carry handle to install a rack-mount kit. The entire side panel must be swapped.
Input Voltage 115 V or 230 V nominal (selected with an internal jumper) with options for high, medium or low (100 V 110 V 120 V) or (200 V 220 V 240 V) using a second internal jumper.
Fan Flow Rate is higher in units with the 02 (rack-mount) option
- TM5006 / TM5006A @ barrytech.com
- Zenwizard Studios Rebuild and Repair @ Zenwizard Studios You Tube
- Zenwizard Studios Rebuild and Repair II @ Zenwizard Studios You Tube
- TM5006 Mainframe load tester @ You Tube