C1001: Difference between revisions
Jump to navigation
Jump to search
(Created page with "<gallery> Tek c1001 1.jpg Tek c1001 2.jpg Tek c1001 3.jpg Tek c1001 4.jpg Tek c1001 5.jpg Tek c1001 6.jpg Tek c1001 7.jpg Tek c1001 8.jpg </gallery>") |
No edit summary |
||
| Line 1: | Line 1: | ||
The '''Tektronix C1001''' is an analog video camera designed to be used with a video frame grabber card in an IBM-compatible PC and Tek waveform processing software. | |||
The camera part was made by NEC and puts out an NTSC signal. | |||
==Parts== | |||
* [[016-0248-01]] mounting adapter for C1001 (or C30 camera) to [[7000-series scopes]] except [[7603]] | |||
* [[016-0269-03]] mounting adapter for 2400 series and [[465]] | |||
* [[016-0306-01]] mounting adapter for older 400 series ([[485]], [[454]] etc.) | |||
* [[DX01]] frame grabber board, with option 01 ([[DCS01]] waveform processing software) | |||
* [[174-0449-00]] DCS cable | |||
==Connectors== | |||
According to [https://groups.io/g/TekScopes/topic/7628465 this posting], ''The camera has a 9-pin [[D-sub connector]] that takes in 12 V, around 300 mA at pins 1 (positive) and 3 (ground) and signal is on pins 4 (shield/ground) and 5 (video); there are two other pins used which bring in calibration voltages and go only to BNC and two test points. '' | |||
==Links== | |||
* [[Media:Handshake_1986-1987_Winter.pdf | Handshake, Winter 1986/87]] | |||
* [[070-6157-00.pdf|070-6157-00 operator manual]] | |||
==Pictures== | |||
<gallery> | <gallery> | ||
Tek c1001 1.jpg | Tek c1001 1.jpg | ||
| Line 9: | Line 28: | ||
Tek c1001 8.jpg | Tek c1001 8.jpg | ||
</gallery> | </gallery> | ||
[[Category:Oscilloscope cameras]] | |||
[[Catgegory:Introduced in 1986]] | |||
Revision as of 06:19, 27 November 2018
The Tektronix C1001 is an analog video camera designed to be used with a video frame grabber card in an IBM-compatible PC and Tek waveform processing software.
The camera part was made by NEC and puts out an NTSC signal.
Parts
- 016-0248-01 mounting adapter for C1001 (or C30 camera) to 7000-series scopes except 7603
- 016-0269-03 mounting adapter for 2400 series and 465
- 016-0306-01 mounting adapter for older 400 series (485, 454 etc.)
- DX01 frame grabber board, with option 01 (DCS01 waveform processing software)
- 174-0449-00 DCS cable
Connectors
According to this posting, The camera has a 9-pin D-sub connector that takes in 12 V, around 300 mA at pins 1 (positive) and 3 (ground) and signal is on pins 4 (shield/ground) and 5 (video); there are two other pins used which bring in calibration voltages and go only to BNC and two test points.
