Neon Lamps

Neon lamps are used for at least three different things in Tek instruments:

1. Indicator lamps, e.g., for power, beam position, uncalibrated status, or a decimal point
2. Voltage clamp, similar to how a zener diode is used
3. In relaxation oscillators, e.g. in 7000-series power supplies

Broken lead (left) on neon in 585 time base

Neon lamps fail more than most other components. A common failure mode is for the leads to break off, often close to the glass bulb, due to corrosion and vibration. Another failure mode is for the I-V characteristic to drift.

Neon lamps are used as a voltage clamp in the CRT circuit for setting the CRT grid voltage in many Tek instruments. A typical example is seen in the 561A:

If the neon lamps fail, the CRT grid voltage will be affected.

Another common use is for DC bias shifting, e.g. in 500-series timebase circuits.

When in doubt, replace the neon lamps. In a pinch, it may be possible to reattach broken leads after careful grinding of the glass.

Types and data

• See Neon lamp specifications

Type	Tek P/N	Voltage		Current	Notes
		Ignition	Operating	Nominal
NE-2	150-002	76 (60−90) V	58 V	0.3 mA
NE-2V	150-030	76 (60−90) V	58 (46-78) V	0.6 mA	short length, formed tip for end-on viewing, mild radioactive additive for the reduction of dark effect
NE-23	150-027	74 (60−90) V	59 V	0.3 mA	mild radioactive additive for reduction of dark effect

Please add

See also

• Nixie tubes
• Voltage regulator tubes