5000 Series plug-in interface: Difference between revisions
Jump to navigation
Jump to search
m (Columns swapped for consistency with 7k page. Reword top.) |
m (Front) |
||
| Line 1: | Line 1: | ||
'''[[5000-series scopes|Tektronix 5000 series oscilloscope mainframes]]''' have three plug-in slots; Two vertical and one horizontal. | '''[[5000-series scopes|Tektronix 5000 series oscilloscope mainframes]]''' have three plug-in slots; Two vertical and one horizontal. | ||
The interconnect on | The interconnect on each slot type is a 56-pin PCB edge connector with 5/32" pitch. | ||
Looking into the mainframe from the front panel, "A" pins are left of the connector centerline and "B" are on the right. Pins are numbered from 1 at the bottom to 28 on the top. | Looking into the mainframe from the front panel, "A" pins are left of the connector centerline and "B" are on the right. Pins are numbered from 1 at the bottom to 28 on the top. | ||
The table below shows the connections as if looking into the | The table below shows the connections as if looking into the mainframe from the front. | ||
{| class="wikitable" | {| class="wikitable" | ||
|+ Description of signals | |+ Description of signals | ||
Latest revision as of 13:24, 14 August 2023
Tektronix 5000 series oscilloscope mainframes have three plug-in slots; Two vertical and one horizontal.
The interconnect on each slot type is a 56-pin PCB edge connector with 5/32" pitch.
Looking into the mainframe from the front panel, "A" pins are left of the connector centerline and "B" are on the right. Pins are numbered from 1 at the bottom to 28 on the top.
The table below shows the connections as if looking into the mainframe from the front.
| Pin | A side Function |
B side Function |
|---|---|---|
| 28 | Ch. 1 Col | Ch. 1 Row |
| 27 | TS1 | TS4 |
| 26 | TS8 | TS9 |
| 25 | TS3 | TS2 |
| 24 | Ch. 2 Col | Ch. 2 Row / Sweep rate |
| 23 | TS5 | TS6 |
| 22 | TS7 | TS10 |
| 21 | −30 V | |
| 20 | Chop activate | |
| 19 | 100 μs/div detect | Display chop |
| 18 | Chop sense | Display on |
| 17 | Lockout A sweep | Single sweep reset |
| 16 | Lockout B sweep | Trace separation |
| 15 | A sweep | ALT drive |
| 14 | Clean GND Return | Clean GND Return |
| 13 | +plugin signal | −plugin signal |
| 12 | Single-sweep mode | |
| 11 | Sample pulse [1] | Load stop [1] |
| 10 | A gate | Z Axis B Sweep |
| 9 | Z Axis A Sweep | Intensify |
| 8 | ||
| 7 | +plugin signal | −plugin signal |
| 6 | +15 V [54xx only!] | −15 V [54xx only!] |
| 5 | +30 V | −30 V |
| 4 | Trig out (H) / Right trig in (V) | Left trig in (V) |
| 3 | Line trigger | |
| 2 | Utility GND | +5 V |
| 1 | +200 V | +38 V unreg |
Notes
Pin group function legend
Plugin power & ground HF signals Readout system signals (5400 series only)