585/Repairs

Supplies out of regulation

Symptom: Several supplies out of regulation

Root cause: dry HV electrolytics

Solution: Rebuild caps using modern replacements

Remove defective cap

Cut can near base, remove guts

Fit modern cap

Epoxy cap onto base

--Peter (talk) 02:45, 4 May 2019 (PDT)

HV low and trace invisible

Symptom: No trace, HV low despite maximum setting

Root cause: HV PIO "Bumble Bee" capacitors leaky (~180 μA at 2 kV); no trace because CRT grid too negative wrt. cathode

Solution: Replace caps with modern ceramic equivalents

old PIO caps in place

old PIO caps removed

new ceramic caps

--Peter (talk) 02:45, 4 May 2019 (PDT)

No trace

Symptom: Trace invisible

Root cause: Wiper of focus pot not in contact

Solution: Disassemble focus pot, clean and re-seat wiper

--Peter (talk) 02:45, 4 May 2019 (PDT)

Trace disappearing

Symptom: Trace fading after ~10 minutes operation

Root cause: HV resonant cap (C808) leaky, overheating (visible bulge)

Solution: Replace cap with modern ceramic equivalent

Thermal image

bulging cap

--Peter (talk) 02:45, 4 May 2019 (PDT)

Time base inoperative

Symptom: No trace

Root cause: Lead of neon bulb in Miller integrator (B171?) broken

Solution: Solder replacement lead after grinding away some glass (or replace neon)

broken lead

repaired leads (before cleaning and epoxy encapsulation)

--Peter (talk) 02:45, 4 May 2019 (PDT)

wavy trace

Symptom: wavy trace

Root cause: C783 (15µF 20V) has high internal resistor (ESR ~ 20 ohms). -12.6 v regulator ciruit is oscillating

Solution: Replacing of electrolytic capacitor C783 with new part.

wavy trace

-12.6 v PSU with new eletrolytics.

--Matt (Matt) 08:53, 5 May 2019 (PDT)