564

The Tektronix 564 is the storage scope of the 560 series, introduced in June 1962. It takes two 2- or 3-series plug-ins. The RM564 is the rack-mount version.

Tektronix 564

Split-screen storage scope

Produced from 1962 to 1974

Manuals

564

Tektronix 564 Manual (PDF)
Tektronix 564 Manual (PDF @ BAMA)]
Tektronix 564 Instrument Reference Book (PDF, needs OCR)
Tektronix 564 Factory Calibration Procedure (PDF, needs OCR)
Media:Tek 564 storage cal outline.pdf

564B

Tektronix 564B Manual (PDF)
Tektronix 564B Manual (PDF @ BAMA)
Tektronix 564B with Mod 121N Manual] (PDF @ BAMA)
Tektronix 564B and 564B Mod 121N Factory Calibration Procedure (PDF, needs OCR)

(All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The 564 is a tube-based oscilloscope, whereas a later version, the 564B (1969), is fully solid state. Mod 121N added auto-erase. The screen has bi-stable storage in two 4 cm × 10 cm sections, allowing independent saving and erasing of the upper and lower half.

The 564 was one of the mainframes offered for the Engine Analyzer package.

Key Specifications

Bandwidth	determined by plug-in (up to 25 MHz available)
Writing speed	≥25 Div/ms with T5640-200; ≥100 Div/ms with T5640-201
Storage time	At least 1 hour
CRT	8×10 Div @ 1 cm/Div, external graticule; tube 154-0410-00/154-0565-00 (standard, P200) / 154-0418-00/154-0565-01 (fast writing speed, P201); 3.5 kV acceleration
Calibrator	564: 0.2 mV to 100 V_p-p in 18 2-5-10 steps, square wave at line frequency 564B: 4 mV to 40 V_p-p in 5 decade steps, square wave at 1 kHz, plus 40 VDC into high impedance, and 2 mV to 0.2 V into 50 Ohms in 3 decade steps.
Power	105−125 V or 210−250 V, 50 to 400 Hz, Convection cooling, thermal cut-off switch; 564: 250 W maximum; 564B: 196 W maximum
Weight	Without plugins: 564 ~13.8 kg (30.5 lbs), 564B ~14.2 kg (31.25 lbs)

Steve Ditter says:

Tek offered two phosphors for the 564. You can determine which one you have by reading the CRT part number, visible in the window in the shield where the deflection plate connections are. 154-0410-00 is P200, which was the standard tube. The 154-0418-00 is the P201, which has faster writing rate, but at the expense of about 30% shorter useful life.

Links

Internals

As in all 560 series scopes, the left plug-in directly drives the vertical deflection plates of the CRT, and the right plug-in directly drives the horizontal deflection plates.

Accessories

The 012-0102-00 Storage Oscilloscope Control Unit that works with the 549 also works with the 564B but not the 564. It provides (corded) remote reset of the sweep and independent erase of the upper and lower storage areas.