37
edits
EIP 101A: Difference between revisions
Jump to navigation
Jump to search
no edit summary
No edit summary |
No edit summary |
||
| Line 15: | Line 15: | ||
{{MissingSpecs}} | {{MissingSpecs}} | ||
Frequency Coverage 1-12.4 GHz (useable . 7 - 15.7 GHz) * | |||
Dial Frequency Accuracy 10 MHz +, 3% ** | |||
'- | |||
Selectable Video Bandwidths 1 KHz, 100 KHz, 3 MHz | |||
Frequency Response + 2 dB typical, ±4 dB maximum | |||
No. of Bands Required to Cover Frequency Range 1 | |||
Calibrated Dispersion 0 - 11. 4 GHz (useable 0 - 15. 0 GHz) | |||
Dispersion Resettability Typical 10MHz | |||
Dispersion Dial Accuracy Typical 10 MHz or ±. 5% whichever is greater | |||
Preselection 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down*** | |||
Resolution Typicall5 MHz | |||
Image Rejection Generates no image signals | |||
Intermod Rejection Intermod signals are reduced by the preselector selectivity over conventional microwave diode response | |||
Type of Receiver Crystal linear or log video with sweeping YIG pre selector | |||
Sensitivity (1 KHz Bandwidth) -45 dBm minimum | |||
Max. Input Power +20 dBm | |||
Limiting Level (2dB compression) . 7 - 1. 0 GHz -20 dBm typical | |||
1. 0 - 1. 2 GHz >+5 dBm | |||
1. 2 - 15.7 GHz >+10 dBm | |||
Log Accuracy (<1 MW Input) ± 1 dB Typical | |||
Variable Vertical Log Scale (dB/cm) Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm | |||
Log Video Out Voltage 0.02 Volts/dB typical | |||
Sweep Rate 1, 10, 30 Hz | |||
Required Assoc. Equipment Scope or other analog display | |||
Plug-In' s available for : Tektronix which accept letter series plug-ins | |||
* Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz. | |||
** If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis. | |||
*** Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response. | |||
==Links== | ==Links== | ||