EIP 101A: Difference between revisions

Jump to navigation Jump to search
398 bytes added ,  13 February 2021
no edit summary
No edit summary
No edit summary
Line 14: Line 14:




{{MissingSpecs}}
{{BeginSpecs}}
Frequency Coverage 1-12.4 GHz (useable . 7 - 15.7 GHz) *
{{Spec | Frequency Coverage | 1-12.4 GHz (useable . 7 - 15.7 GHz)* }}
Dial Frequency Accuracy 10 MHz +, 3% **
{{Spec | Dial Frequency Accuracy | 10 MHz +, 3% ** }}
'-
{{Spec | Selectable Video Bandwidths | 1 KHz, 100 KHz, 3 MHz }}
Selectable Video Bandwidths 1 KHz, 100 KHz, 3 MHz
{{Spec | Frequency Response | + 2 dB typical, ±4 dB maximum }}
Frequency Response + 2 dB typical, ±4 dB maximum
{{Spec | Calibrated Dispersion | 0 - 11. 4 GHz (useable 0 - 15. 0 GHz) }}
No. of Bands Required to Cover Frequency Range 1
{{Spec | No. of Bands Required to Cover Frequency Range  | 1  }}
Calibrated Dispersion 0 - 11. 4 GHz (useable 0 - 15. 0 GHz)
{{Spec | Dispersion Resettability | Typical 10MHz }}
Dispersion Resettability Typical 10MHz
{{Spec | Dispersion Dial Accuracy | Typical 10 MHz or ±. 5% whichever is greater }}
Dispersion Dial Accuracy Typical 10 MHz or ±. 5% whichever is greater
{{Spec | Preselection | 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down*** }}
Preselection 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down***
{{Spec | Resolution | Typicall5 MHz }}
Resolution Typicall5 MHz
{{Spec | Image Rejection | Generates no image signals }}
Image Rejection Generates no image signals
{{Spec | Intermod Rejection | Intermod signals are reduced by the preselector selectivity over conventional microwave diode response }}
Intermod Rejection Intermod signals are reduced by the preselector selectivity over conventional microwave diode response
{{Spec | Type of Receiver | Crystal linear or log video with sweeping YIG pre selector }}
Type of Receiver Crystal linear or log video with sweeping YIG pre selector
{{Spec | Sensitivity (1 KHz Bandwidth) | -45 dBm minimum }}
Sensitivity (1 KHz Bandwidth) -45 dBm minimum
{{Spec | Max. Input Power | +20 dBm }}
Max. Input Power +20 dBm
{{Spec | Limiting Level (2dB compression) | 0.7 - 1.0 GHz -20 dBm typical }}
Limiting Level (2dB compression) . 7 - 1. 0 GHz -20 dBm typical
{{Spec |  | 1.0 - 1.2 GHz >+5 dBm }}
1. 0 - 1. 2 GHz >+5 dBm
{{Spec |  | 1.2 - 15.7 GHz >+10 dBm }}
1. 2 - 15.7 GHz >+10 dBm
{{Spec |  Log Accuracy (<1 MW Input) | ± 1 dB Typical }}
Log Accuracy (<1 MW Input) ± 1 dB Typical
{{Spec | Variable Vertical Log Scale (dB/cm) | Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm }}
Variable Vertical Log Scale (dB/cm) Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm
{{Spec | Log Video Out Voltage  | 0.02 Volts/dB typical  }}
{{Spec | Sweep Rate  | 1, 10, 30 Hz  }}
{{Spec | Required Assoc. Equipment  | Scope or other analog display  }}
{{Spec | Plug-In' s available for:  | Tektronix which accept letter series plug-ins  }}
{{Spec |
* Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz.
** If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis.
*** Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response.  |  }}
{{EndSpecs}}


Log Video Out Voltage 0.02 Volts/dB typical


Sweep Rate 1, 10, 30 Hz


Required Assoc. Equipment Scope or other analog display
Plug-In' s available for : Tektronix which accept letter series plug-ins
* Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz.
** If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis.
*** Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response.




37

edits

Navigation menu