PG508: Difference between revisions

PG508 (view source)

146 bytes added , 10 December 2021

no edit summary

39,344

edits

@@ Line 21: / Line 21: @@
 ==Rear Interface==
-(right-hand plug-in slot as viewed from front)
+(on right-hand plug-in slot as viewed from front)
-* 27B/28B(GND) Trig output (complement polarity installed; for normal polarity, front panel input requires optional cable and front output disconnection) ''[note error on manual p.1-12; table 1-13 is correct]''
+{| class="wikitable"
-* 24B/25B(GND) Trig input (with optional cable, front panel input must be disconnected)
+|-
-* 25A/26A(GND) Amplitude Monitor (from output via 27 kΩ)
+! colspan="2" | Connector Pin
-* 22A External Low Level Control Input (requires internal jumper and trim)
+! rowspan="2" | Description
-* 22B External High Level Control Input (requires internal jumper and trim)
+|-
+! Signal
+! Return
+|-
+| 27B || 28B || Trig output (complement polarity installed; for normal polarity, front panel input requires optional cable and front output disconnection) ''[note error on manual p.1-12; table 1-13 is correct]''
+|-
+| 24B || 25B || Trig input (with optional cable, front panel input must be disconnected)
+|-
+| 25A || 26A || Amplitude Monitor (from output via 27 kΩ)
+|-
+| 22A ||     || External Low Level Control Input (requires internal jumper and trim)
+|-
+| 22B ||     || External High Level Control Input (requires internal jumper and trim)
+|}
 Custom connection solder pads are available on the left plug-in slot, which is otherwise used only for the associated pass transistors in the mainframe.