1200C01: Difference between revisions
No edit summary |
m (typos) |
||
Line 14: | Line 14: | ||
The '''1200C01''' is a [[RS232]] COMM pack for the [[1240]], [[1241]] and [[3001GPX]] logic analyzers. It gives the device the ability to communicate and print using the RS-232 protocol. | The '''1200C01''' is a [[RS232]] COMM pack for the [[1240]], [[1241]] and [[3001GPX]] logic analyzers. It gives the device the ability to communicate and print using the RS-232 protocol. | ||
The board layout and schematic is in the [[1240]] service manual vol 2, fig 10-28, board A31, schematic 41. | The board layout and schematic is in the [[1240]] service manual vol 2, fig 10-28, board A31, schematic 41. | ||
Attaching to a PC can be accomplished with a null modem cable. cross TX/RX (pin2,3) and DSR(pin 4) to DTR(pin 6) to get carrier detect, then communication commands is same as the GPIB module [[1200C02]] see section 2-4 in [[Media:070-4344-00.pdf|1200C02 Instructions (PDF)]]. Capabilities of the device | Attaching to a PC can be accomplished with a null modem cable. cross TX/RX (pin2,3) and DSR(pin 4) to DTR(pin 6) to get carrier detect, then communication commands is same as the GPIB module [[1200C02]] see section 2-4 in [[Media:070-4344-00.pdf|1200C02 Instructions (PDF)]]. Capabilities of the device include remote control of the analyzer, save/load setup, capturing data and transfer of captured data over the serial line. | ||
When combined with a disassembler ROM pack, new menu options is available to use this COMM pack to print/transfer disassembled code via serial output. | When combined with a disassembler ROM pack, new menu options is available to use this COMM pack to print/transfer disassembled code via serial output. |
Revision as of 14:41, 12 August 2023
The 1200C01 is a RS232 COMM pack for the 1240, 1241 and 3001GPX logic analyzers. It gives the device the ability to communicate and print using the RS-232 protocol. The board layout and schematic is in the 1240 service manual vol 2, fig 10-28, board A31, schematic 41. Attaching to a PC can be accomplished with a null modem cable. cross TX/RX (pin2,3) and DSR(pin 4) to DTR(pin 6) to get carrier detect, then communication commands is same as the GPIB module 1200C02 see section 2-4 in 1200C02 Instructions (PDF). Capabilities of the device include remote control of the analyzer, save/load setup, capturing data and transfer of captured data over the serial line.
When combined with a disassembler ROM pack, new menu options is available to use this COMM pack to print/transfer disassembled code via serial output.