1200C01: Difference between revisions
(Add link to 1200C01 rs232 comm pack instructions with 070-6675-02 document id) |
m (ROMs to side panel) |
||
| (7 intermediate revisions by 3 users not shown) | |||
| Line 11: | Line 11: | ||
* [[Media:070-6675-02.pdf|Tektronix 1200C01 Installation Instructions]] | * [[Media:070-6675-02.pdf|Tektronix 1200C01 Installation Instructions]] | ||
* ''070-4343-00 1200C01 COMM Pack Operator’s Manual needed – please add'' [[Category:Manual needed]] | * ''070-4343-00 1200C01 COMM Pack Operator’s Manual needed – please add'' [[Category:Manual needed]] | ||
{{ROM Images}} | |||
* [[Media:160-1915-00.bin |1200C01 U126]] | |||
* [[Media:160-1915-01.bin |1200C01 U126]] | |||
}} | }} | ||
The '''1200C01''' is a [[RS232]] COMM pack for the [[1240]], [[1241]] and [[3001GPX]] logic analyzers. It gives the device the ability to communicate and print | The '''1200C01''' is a [[RS232]] COMM pack for the [[1240]], [[1241]] and [[3001GPX]] logic analyzers. It gives the device the ability to communicate and print through a serial interface. | ||
Connecting to a PC requires a null modem cable, crossing TX/RX (pins 2/3) and DSR (4) to DTR (6). Communication commands are the same as for the GPIB module [[1200C02]] (see section 2-4 in the [[Media:070-4344-00.pdf|1200C02 Instruction Manual]]). Capabilities of the device include remote control of the analyzer, save/load setup, capturing data and transfer of captured data over the serial line. | |||
When combined with a disassembler ROM pack, new menu options are available to use the COMM pack to print/transfer disassembled code via serial output. | |||
==Internals== | |||
The board layout and schematic can be found in the [[1240]] service manual vol 2, fig 10-28, board A31, schematic 41. | |||
==Pictures== | ==Pictures== | ||
Latest revision as of 13:24, 25 August 2023
The 1200C01 is a RS232 COMM pack for the 1240, 1241 and 3001GPX logic analyzers. It gives the device the ability to communicate and print through a serial interface.
Connecting to a PC requires a null modem cable, crossing TX/RX (pins 2/3) and DSR (4) to DTR (6). Communication commands are the same as for the GPIB module 1200C02 (see section 2-4 in the 1200C02 Instruction Manual). Capabilities of the device include remote control of the analyzer, save/load setup, capturing data and transfer of captured data over the serial line.
When combined with a disassembler ROM pack, new menu options are available to use the COMM pack to print/transfer disassembled code via serial output.
Internals
The board layout and schematic can be found in the 1240 service manual vol 2, fig 10-28, board A31, schematic 41.
