7D01: Difference between revisions
(year 1976 per Tekscope V8 N2) |
No edit summary |
||
| Line 11: | Line 11: | ||
* [http://w140.com/tekscope_1976vol8no2_7d01.pdf 7D01 Article in 1976 Volume 8 Number 2 Tekscope (PDF)] | * [http://w140.com/tekscope_1976vol8no2_7d01.pdf 7D01 Article in 1976 Volume 8 Number 2 Tekscope (PDF)] | ||
}} | }} | ||
The '''Tektronix 7D01''' is a logic analyzer plug-in for the [[7000-series scopes]]. | The '''Tektronix 7D01''' is a logic analyzer plug-in for the [[7000-series scopes]]. Compatible extension modules | ||
include the [[DF1]] and [[DF2]] display formatters and the [[DL2]] latch (glitch detector). | |||
{{BeginSpecs}} | {{BeginSpecs}} | ||
Revision as of 04:40, 14 May 2016
Template:Plugin Sidebar 2 The Tektronix 7D01 is a logic analyzer plug-in for the 7000-series scopes. Compatible extension modules include the DF1 and DF2 display formatters and the DL2 latch (glitch detector).
Key Specifications
| Channels |
Note about external clock rates (from Jim Mauck): When I was a Tek Service Technician I worked on the 7D01. For several years I tested every 7D01 I worked on (and that was a lot of them) with a 100MHz external clock in 16 channel mode. I would use a DF2 and set it to reacquire continuously as long as the 7D01 memory was the same as the original data I stored into the DF2 memory. The analyzer would run for hours without error. The funny part is that it wasn't until I had been doing this for several years that I realized it wasn't specified to run at that frequency. I continued to test them that way even after I discovered my error. However the instrument exceeding the specifications might be due to the data source providing a generous setup and hold time relative to the active clock edge. |
|---|---|
| Sampling Rate | 10 ns to 5 ms per sample (1—2—5) or external clock up to 50 MHz |
| Trigger Sources |
|
please add
