PG506: Difference between revisions

Revision as of 18:16, 12 October 2021

Tektronix PG506
1 MHz calibration generator Tektronix PG506 Produced from 1974 to 1993 Manuals Tektronix PG506 Manual for sn 39999 and below (OCR, PDF) Tektronix PG506 Manual for sn 40000 and above (split schematics, OCR, PDF) Tektronix PG506 Manual for sn 40000 and above (whole schematics, OCR, PDF) (All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The Tektronix PG506 is a 1 MHz calibration generator plug-in for the TM500 system.

It functionally replaces the 067-0502-01 in the "standard amplitude" mode, and the 106 in the "fast rise" and "high amplitude" modes.

There are (at least) two versions of the PG506. The older version has two relays that switch a low-pass (noise) filter into the 10 V and below ranges. The new version just has a capacitor across the output for these ranges.

Common failure modes: In case of low or no output on the 20 V and above ranges, check Q270, Q280 and Q290.

Pictures

PG506 older version

PG506 newer version

PG506 Left Internal
PG506 Left Internal
PG506 Right Internal
PG506 Right Internal

PG506A

PG506A Front
Newer version without filter relays
PG506A
PG506A output waveform

Revision as of 05:00, 1 October 2021 (view source) Peter (talk \| contribs) No edit summary ← Older edit		Revision as of 18:16, 12 October 2021 (view source) Gregor (talk \| contribs) No edit summary Newer edit →
Line 38:		Line 38:

	[[Category:Specifications needed]]		[[Category:Specifications needed]]
			[[Category:Amplitude Calibrator]]