7A29: Difference between revisions
(year) |
m (caption) |
||
Line 30: | Line 30: | ||
<gallery> | <gallery> | ||
File:7a29 manual photo.jpg|photo of 7A29 from manual (normal and option 4 units) | |||
File:7a29 input amp schem.png| input amplifier schematic | |||
File:7a29 output amp schem.png| output amplifier schematic | |||
File:Tek 7a29 left.jpg|7A29, left view | File:Tek 7a29 left.jpg|7A29, left view (Opt. 4 variable delay line enclosure above PCB) | ||
File:Tek 7a29 amps.jpg|7A29 amplifiers | File:Tek 7a29 amps.jpg|7A29 amplifiers | ||
File:Tek 7a29 right rear.jpg|7A29, right side, rear | File:Tek 7a29 right rear.jpg|7A29, right side, rear |
Revision as of 11:12, 17 October 2014
Template:Plugin Sidebar 2 The Tektronix 7A29 is a 1 GHz single-channel vertical plug-in for 7000-series scopes. It is primarily intended for the 7103 and 7104. Like the 7A19, it has no variable gain control, but a variable signal delay was available as an option.
The 7A29 uses a "feed-beside" scheme to compensate for low-frequency anomalies in the frequency response that are attributed to transistor heating. The input connector is a special Tek-made part that is exactly 50 Ω. Typical BNC connectors are around 52 Ω.
There is also a 7A29P, which has digitally programmable gain, intended for the 7000 series digitizers.
Specifications
- Bandwidth: 1 GHz (in 7104)
- Input impedance: 50 Ω
- 10 mV/div to 1V/div
- single channel
- Option 4: variable delay
Pictures
-
photo of 7A29 from manual (normal and option 4 units)
-
input amplifier schematic
-
output amplifier schematic
-
7A29, left view (Opt. 4 variable delay line enclosure above PCB)
-
7A29 amplifiers
-
7A29, right side, rear
-
7A29, right side, front
-
7A29P