S-53

The Tektronix S-53 Trigger Recognizer is essentially the entire trigger circuit of an oscilloscope.

{{{manufacturer}}} {{{type}}}

Trigger Recognizer

Compatible with [[3S2, 7S11, 7S12 Sampling Plugins]]

Produced from {{{introduced}}} to {{{discontinued}}}

Manuals

(All manuals in PDF format unless noted otherwise)

[[Category:Introduced in {{{introduced}}}]]

Manuals – Specifications – Links – Pictures

The S-53 uses tunnel diode triggering with an amplifier before the tunnel diode.

The signal first passes through a compensated NPN differential amplifier, Q10 and Q12, which provides an adjustable trigger offset voltage and trigger polarity selection. Switching diodes CR6 and CR8 are used for selecting the trigger polarity. The differential amplifier (i.e., phase splitter) generates both phases, inverted and non-inverted. Depending on the position of the trigger polarity switch, one or the other of the phases is shunted by 200 Ω resistor. The two signals are buffered by common-base amplifiers Q20 and Q22, whose collector currents are summed. R25 sets up a bias current on trigger tunnel diode CR25. The extra current from Q20 or Q22 pushes CR25 over its peak current, and it switches to the high voltage state.

Specifications

Key Specifications

Bandwidth	1 GHz
Input impedance	50 Ω BNC connector
Jitter	max. 15 ps or less (from input signal to trigger-out)
Trigger-out signal	1 V into 50 Ω with 600 mV/ns slew rate

Pictures

Front
Front
S-53 in a 7S12 displaying a 1 GHz sine using a S-6 sampling head. 2^nd channel (top) on a 7S11 with S-4 sampling head.
Schematic