T: Difference between revisions

3 bytes added ,  4 February 2018
no edit summary
No edit summary
No edit summary
Line 11: Line 11:
* [http://w140.com/tek_fcp/tek_type_t_factory_cal_proc.pdf Tektronix Type T Factory Calibration Procedure (PDF)]
* [http://w140.com/tek_fcp/tek_type_t_factory_cal_proc.pdf Tektronix Type T Factory Calibration Procedure (PDF)]
}}
}}
The '''Tektronix Type T''' is a timebase plug-in primarily intended for use in the [[536]] X-Y scope. It contains trigger and sweep circuitry. The typical use of a Type T plug-in is as the X-axis plug-in in a 536, to make the 536 behave like a normal oscilloscope instead of an X-Y scope. However, there is no capability for internal triggering – a jumper must be connected from the Vertical Signal Out on the 536 to the External Trig on the T.  
The '''Tektronix Type T''' is a timebase plug-in primarily intended for use in the [[536]] X-Y scope.
It contains trigger and sweep circuitry.
The typical use of a Type T plug-in is as the X-axis plug-in in a 536,
to make the 536 behave like a normal oscilloscope instead of an X-Y scope.
However, there is no capability for internal triggering – a jumper must be connected
from the Vertical Signal Out on the 536 to the External Trig on the Type T.  


Plugging a Type T in a vertical slot of a normal [[500-series scopes|500-series scope]]  
Plugging a Type T in a vertical slot of a normal [[500-series scopes|500-series scope]]