T: Difference between revisions

T (view source)

3 bytes added , 4 February 2018

no edit summary

33,180

edits

@@ Line 11: / Line 11: @@
 * [http://w140.com/tek_fcp/tek_type_t_factory_cal_proc.pdf Tektronix Type T Factory Calibration Procedure (PDF)]
 }}
-The '''Tektronix Type T''' is a timebase plug-in primarily intended for use in the [[536]] X-Y scope.  It contains trigger and sweep circuitry.  The typical use of a Type T plug-in is as the X-axis plug-in in a 536, to make the 536 behave like a normal oscilloscope instead of an X-Y scope. However, there is no capability for internal triggering – a jumper must be connected from the Vertical Signal Out on the 536 to the External Trig on the T.
+The '''Tektronix Type T''' is a timebase plug-in primarily intended for use in the [[536]] X-Y scope.
+It contains trigger and sweep circuitry.
+The typical use of a Type T plug-in is as the X-axis plug-in in a 536,
+to make the 536 behave like a normal oscilloscope instead of an X-Y scope.
+However, there is no capability for internal triggering – a jumper must be connected
+from the Vertical Signal Out on the 536 to the External Trig on the Type T.
 Plugging a Type T in a vertical slot of a normal [[500-series scopes|500-series scope]]