P64xx input leads
Jump to navigation
Jump to search
Logic probes from the Tektronix P64xx series share a common 10-lead input connector layout.
These probes include the P6406, P6407, P6408, P6450, P6451, P6452, P6455, P6460, P6462, A6701 and possibly others.
Original input lead sets were
- 012-0386-00 − ten individual leads
- 012-0551-00 − 10+2 wide comb to 20 position double row connector. Used with P6455, P6456 and P6457 pattern generator probes.
- 012-0556-00 − diagnostic leads to connect P6460 to diagnostic test points and test pattern generator outputs of 1240/1241 logic analyzers
- 012-0655-01 − ten individual 40 cm leads
- 012-0655-02 − ten individual 8 cm leads
- 012-0670-00 − ten individual 16 cm leads
- 012-0747-00 − standard 10-wire 10 in/25 cm with pluggable probe tips
- 012-0800-00 − 10-wire comb to 10 position single row Harmonica connector (25mil square pins in 100mil spacing) 10 cm long
- 012-0926-00 − 20 twisted pair leads. Possibly provided with P6455, P6456 and P6457 pattern generator probes.
- 012-0968-00 − 10-wire comb to 10 position single row Harmonica connector (25mil square pins in 100mil spacing) 5 cm long
- 012-0987-00 − 10-wire 5 in/12 cm with pluggable probe tips P6460
- 012-0989-00 − Ground VL Sense Lead, 5 inch with Pomona Hook
- 012-0990-00 − 2 pin interface to single grabber
- 012-1000-00 − diagnostic lead set for the P6452 logic probe.
- 012-1053-00 − 10+6 wide comb to VH and VL hook tips and twisted pair leads to 25mil square pins. Used with P6455, P6456 and P6457 pattern generator probes.
- 103-0209-00 − 2 x ten bundled leads connecting to a standard GPIB connector, to be used with two probes. Supplied with the DF2
As the probe-side input connector is a standard .65 mm square pin header on a 0.2" (5.08 mm) pitch, it is also possible to use standard jumper wires with pins, sockets or clips on the other end for connecting inputs.