EIP 101A: Difference between revisions

Jump to navigation Jump to search
384 bytes removed ,  9 May 2023
Specs formatted (no empty parameters in Spec template please)
No edit summary
(Specs formatted (no empty parameters in Spec template please))
Line 17: Line 17:


{{BeginSpecs}}
{{BeginSpecs}}
{{Spec | Frequency Coverage | 1 - 12.4 GHz (useable 0.7 - 15.7 GHz)* }}
{{Spec | Frequency Range | 1 12.4 GHz (useable 0.7 15.7 GHz)<sup>*</sup>}}
{{Spec | Dial Frequency Accuracy | 10 MHz +/-3% ** }}
{{Spec | Dial Frequency Accuracy | 10 MHz ±3%<sup>**</sup>}}
{{Spec | Selectable Video Bandwidths | 1 KHz, 100 KHz, 3 MHz }}
{{Spec | Video Bandwidth | 1 kHz, 100 kHz, 3 MHz }}
{{Spec | Frequency Response | + 2 dB typical, ±4 dB maximum  }}
{{Spec | Frequency Response | ±2 dB typical, ±4 dB maximum  }}
{{Spec | Calibrated Dispersion  | 0 - 11.4 GHz (useable 0 - 15.0 GHz) }}
{{Spec | Calibrated Dispersion  | 0 11.4 GHz (useable 0 - 15.0 GHz)  }}
{{Spec | No. of Bands Required to Cover Frequency Range  | 1 }}
{{Spec | Dispersion Resettability  | 10 MHz  }}
{{Spec | Dispersion Resettability  | Typical 10 MHz  }}
{{Spec | Dispersion Dial Accuracy  | 10 MHz or ±0.5% whichever is greater  }}
{{Spec | Dispersion Dial Accuracy  | Typical 10 MHz or ±0.5% whichever is greater  }}
{{Spec | Preselection  | 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down<sup>***</sup> }}
{{Spec | Preselection  | 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down*** }}
{{Spec | Resolution  | 15 MHz typ. }}
{{Spec | Resolution  | Typical 15 MHz }}
{{Spec | Image Rejection | Generates no image signals  }}
{{Spec | Image Rejection | Generates no image signals  }}
{{Spec | Intermod Rejection  | Intermod signals are reduced by the preselector selectivity over conventional microwave diode response  }}
{{Spec | Intermod Rejection  | Intermod signals are reduced by the preselector selectivity over conventional microwave diode response  }}
{{Spec | Type of Receiver  | Crystal linear or log video with sweeping YIG pre selector  }}
{{Spec | Sensitivity | −45 dBm min. (1 kHz bandwidth)  | }}
{{Spec | Sensitivity (1 KHz Bandwidth)  | -45 dBm minimum  }}
{{Spec | Max. Input Power  | +20 dBm  }}
{{Spec | Max. Input Power  | +20 dBm  }}
{{Spec | Limiting Level (2dB compression)  | 0.7 - 1.0 GHz -20 dBm typical  }}
{{Spec | Limiting Level | 0.7 1.0 GHz -20 dBm typ., 1.0 1.2 GHz >+5 dBm, 1.2 15.7 GHz >+10 dBm (all at 2 dB compression) }}
{{Spec |  | 1.0 - 1.2 GHz >+5 dBm }}
{{Spec | Log Accuracy | ±1 dB typ. (<1 mW input)  }}
{{Spec |  | 1.2 - 15.7 GHz >+10 dBm }}
{{Spec | Log Accuracy (<1 MW Input) | ± 1 dB Typical }}
{{Spec | Variable Vertical Log Scale (dB/cm)  | Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm  }}
{{Spec | Variable Vertical Log Scale (dB/cm)  | Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm  }}
{{Spec | Log Video Out Voltage | 0.02 Volts/dB typical  }}
{{Spec | Log Video output | 0.02 Volts/dB typ. }}
{{Spec | Sweep Rate  | 1, 10, 30 Hz  }}
{{Spec | Sweep Rate  | 1, 10, 30 Hz  }}
{{Spec | Required Assoc. Equipment  | Scope or other analog display  }}
{{Spec | Plug-In' s available for:  | Tektronix which accept letter series plug-ins  }}
{{Spec | | * Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz. |  }}
{{Spec | | ** If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis. |  }}
{{Spec | | *** Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response. | }}
{{EndSpecs}}
{{EndSpecs}}
 
:<sup>*</sup> Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz.
 
:<sup>**</sup> If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis.
:<sup>***</sup>Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response.
 
 
 
==Links==


==Pictures==
==Pictures==
<gallery>
<gallery>
EIP101A_front_ISO.jpg
EIP101A_front_ISO.jpg

Navigation menu