7A29: Difference between revisions
No edit summary |
No edit summary |
||
| Line 8: | Line 8: | ||
series=[[7000-series scopes]] | | series=[[7000-series scopes]] | | ||
manuals= | manuals= | ||
* [http://w140.com/smb/7a29_sm.pdf Tektronix 7A29 (OCR, PDF)] | * [http://w140.com/smb/7a29_sm.pdf Tektronix 7A29 (OCR, PDF)] | ||
}} | }} | ||
The '''Tektronix 7A29''' is a 1 GHz single-channel vertical plug-in for [[7000-series scopes]]. It is primarily intended for the [[7103]] and [[7104]]. | The '''Tektronix 7A29''' is a 1 GHz single-channel vertical plug-in for [[7000-series scopes]]. It is primarily intended for the [[7103]] and [[7104]]. | ||
Like | Like with the [[7A19]], a variable signal delay was available as an option. | ||
There is also a [[7A29P]], which has digitally programmable gain, intended for the [[:Category:7000 series digitizer mainframes|7000 series digitizers]]. | There is also a [[7A29P]], which has digitally programmable gain, intended for the [[:Category:7000 series digitizer mainframes|7000 series digitizers]]. | ||
| Line 21: | Line 20: | ||
* Input impedance: 50 Ω | * Input impedance: 50 Ω | ||
* 10 mV/div to 1V/div | * 10 mV/div to 1V/div | ||
* | * Single channel | ||
* Option 4: variable delay | * Option 4: variable delay | ||
| Line 47: | Line 46: | ||
[[Category:7000 series vertical plugins]] | [[Category:7000 series vertical plugins]] | ||
Revision as of 05:26, 16 August 2015
Template:Plugin Sidebar 2 The Tektronix 7A29 is a 1 GHz single-channel vertical plug-in for 7000-series scopes. It is primarily intended for the 7103 and 7104. Like with the 7A19, a variable signal delay was available as an option.
There is also a 7A29P, which has digitally programmable gain, intended for the 7000 series digitizers.
Specifications
- Bandwidth: 1 GHz (in 7104)
- Input impedance: 50 Ω
- 10 mV/div to 1V/div
- Single channel
- Option 4: variable delay
Internals
The 7A29 employs a number of Tek-made custom Hypcon-packaged hybrids, the 155-0180-00 fast input protection, 155-0181-00 input amplifier and 155-0175-00 trigger amplifier (2 ×).
It uses a "feed-beside" scheme to compensate for low-frequency anomalies in the frequency response that are attributed to transistor heating. The input connector is a special Tek-made part that is exactly 50 Ω. Typical BNC connectors are around 52 Ω.
Pictures
-
photo of 7A29 from manual (normal and option 4 units)
-
input amplifier schematic
-
output amplifier schematic
-
7A29, left view (Opt. 4 variable delay line enclosure above PCB)
-
7A29 amplifiers
-
7A29, right side, rear
-
7A29, right side, front
-
7A29P
