585: Difference between revisions

Revision as of 09:35, 8 April 2018

{{{manufacturer}}}
100 MHz oscilloscope Tektronix 585A Produced from 1959 to 1972 Manuals Tektronix 585 Manual (PDF) Tektronix 585A Manual (PDF) Tektronix 585 Factory Calibration Procedure (PDF) 580 series gain adjustment procedure, in Service Scope 39, Aug 1966 Tektronix 585A Operators Handbook (PDF) (All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The Tektronix 585 is a 100 MHz 580-Series scope introduced by Tektronix in 1959 and made through the 1960s. (The 585A was discontinued after 1971.)

Key Specifications

please add

Internals

Plug-in Interface

The 585 uses 580-series plug-ins, which look like letter-series and 1-series plug-ins but are electrically different, primarily in the impedance of the signal interface between the plug-in and the scope. The pin-out is also different: it's essentially flipped 180° from its 530/540/550 series counterparts. 'Signal out' is on 14/16 as opposed to 1/3, etc...

The Type 81 adapter allows the use of letter-series and 1-series plug-ins in a 585.

Trigger Circuit

The original 585 (up to serial number 1070) has an "A" trigger circuit that has a differential trigger amplifier made of a pair of 6EW6 miniature pentodes, followed by a Schmitt trigger made of a pair of miniature dual triode tubes.

Starting at serial number 1071, the miniature dual triode Schmitt trigger was replaced by a 10 mA tunnel diode and a pulse amplifier made with an OC171 germanium PNP transistor. The tunnel diode is AC-coupled to the base-emitter junction of the transistor.

Vertical Signal Path

Like the 545, 551, and 555, the 585 uses a distributed amplifier for vertical deflection. Unlike the other 500-series scopes, the 585 uses a CRT with distributed vertical deflection plates, the T581, enabling it to have both high sensitivity and fast risetime. Total CRT acceleration voltage is 10 kV.

Several improvements were published for the 585 circuitry, including the enhanced trigger circuit. If all of those changes are applied to a 585, it is essentially a 585A.

Rackmount Versions

Rackmount versions were also made, the RM585 and RM585A.

Pictures

585 non-A

585 with 81 and CA
585 with 82
Bottom
Delay line driver amplifier
Delay line driver amplifier (bottom)
Left side
Vertical amplifier (post-delay 5-stage distributed amplifier)
Vertical amplifier (5-stage dist amp, power output stage)
Rectifiers
Time Base A
Top view

585A

585A with 82
585A trigger circuit
White plastic clip holds tunnel diode for triggering
Inside view shows regulator tubes
Distributed vertical amplifier
T5810P31 distributed deflection plates
585A delay line
585A delay line
585A delay line
585 with TRIGGER SOURCE switch upgraded to 585A design
585A on cart
585A with 81A and Hickok plug-in
Direct Connection to CRT (from 1964 Service Scope)

RM585A

RM-585A

@@ Line 50: / Line 50: @@
 ==585 non-A==
 <gallery>
-Tek-585-82.jpg | 585 with [[82]] and [[CA]]
+Tek-585-82.jpg | 585 with [[81]] and [[CA]]
 Tek 585 with 82.jpg|585 with [[82]]
 Tek585-bottom.jpg  | Bottom