Probe power

Many Tektronix instruments provide power for active probes. A number of different configurations were used over time:

• The 513 provides +225 V, +6.3 V, and a variable supply producing +15 V to +150 V, on a 4-pin connector.
• The 517, 128 and 1121 provide +120 V and +6.3 V for P170CF or P500CF cathode-follower probes.
• The 1S1, 3S1 and 3S76 provide +100 V and −12.2 V for P6032 cathode-follower probes or 282 active adapters. (The 1S1 supplies -19 V through a 35 Ω resistor to pin B, creating about -12 V when accounting for the filament current of the P6032.)
• The 4S1 and 4S2 provides +100 V, −12.6 V, and −25.2 V for P6032 probes or 282 active adapters.
• The N provides +100 V and 6.3 V_AC for P6025 cathode-follower probes. Type N units with serial numbers under 221 didn't come with probe power. A mod kit was available to add probe power to pre-sn221 Type N units.
• The 015-0073-00 has a 3-pin probe power connector (Sealectro 55-850-0018-98(?)), the 454/454A a pair of these, providing +12.5 V and −12.5 V for probes P6045, ...
• 7000-series scopes (not all models), 475, 485, the 1101 probe power supply, the 2707 tracking generator, and most 49X-Series Spectrum Analyzers provide +15 V, +5 V, and −15 V through a LEMO S-series connector for probes like P6201, P6202A, P6230, P6051 etc.
• TekProbe BNC, TekProbe SMA and TekConnect are proprietary probe-scope interfaces that combine signal and probe power as well as control (e.g. offset voltage), and provide the scope with information about the type of probe connected.

• 

  Probe power connector on rear panel of 7104

• 

  7000 series probe power pinout

• 

  TekProbe connector

• 

  TekProbe 2 Pinout

• 

  TekProbe SMA connector

• 

  513 probe power connector

• 

  454/015-0073-00 probe power connector

• 

  3S76 probe power connector (identical to 3S1 pinout, similar to 1S1)

• 

  4S2 probe power connector (identical to 4S1 pinout)