11A32

Manuals – Specifications – Links – Pictures

The Tektronix 11A32 is a 400 MHz dual-channel amplifier plug-in for 11000-series scopes. Each of the attenuator modules contains an M474 buffer amplifier. Each of the attenuator modules feeds an M377 amplifier IC. The output signals of the two M377s combine at the output of the 11A32. The fine steps between the deflection ranges are calibrated in 1% increments.

The 11A32 uses the same firmware as the 11A34.

Key Specifications

Bandwidth	DC to 400 MHz plus 100 MHz and 20 MHz BWL filters
Rise time	875 ps in 1 GHz mainframe such as the 11402, 11402A, 11403, 11403A, DSA601A, or DSA602A
Deflection	1 mV to 10 V per division in 1% calibrated steps
Input impedance	50 Ω or 1 MΩ
Features	High-Resolution Calibrated DC Offset Fast Overdrive Recovery 50 Ω mode: 5 V RMS overload protected with manual reset

Internals

The 11A32 and 11A34 were originally intended to use Intel 8052 microcontrollers. However, during development, the firmware swelled beyond that chip's 8192-byte maximum on-chip ROM size. Doug Haines found an alternate supplier of 8051-compatible chips (OKI Semiconductor) that offered a 16Kbyte on-chip ROM, and that's what the plug-ins wound up with. The finished code size wound up at about 14 KB.

The 11A32 also contains a DS1120 NVRAM and an ACVS sample and hold module.

Links

• 11A-series plug-in NVRAM replacement
• Tek 11A32 @ barrytech.com

Pictures

• 
• 
• 

  11A32 Main Board Schematic

• 

  11A32 Main Interface

• 

  left side internal

• 

  right side internal

Custom ICs used in the 11A32