7503

Manuals – Specifications – Links – Pictures

The Tektronix 7503 is a 90 MHz 7000-series mainframe with three module bays, introduced in 1970. It was effectively replaced by the larger-screen 7603 in 1972.

The 7503 project was managed by Phil Crosby, and was supposed to be a 7504 but with one fewer plug-in. The 7503 was Tek's first scope to use a harmonica connector for inter-board wiring. Prior to this, inter-board wiring had either mainly been point-to-point soldered. Other approaches were taken on certain instruments, for example the 7704, in which pins sticking out of the chassis mate with holes in the boards that receive the pins and make electrical contact.

Key Specifications

Bandwidth	90 MHz with 7A11, 7A16 (and faster plug-ins); 75 MHz with 7A12, 7A13, 7A14
Fastest calibrated sweep	5 ns/Div
CRT	154-0608-xx
Vertical modes	Left / Alt / Add / Chop / Right
Trigger Source	Left / Vert Mode / Right
Calibrator	4 mV to 40 V in five decade steps, 40 mA, 1 kHz ±0.5%
Outputs	Side panel: Vert signal, +Gate, +Sawtooth; At CRT: Camera power
Line Voltage	90-110 V / 104-126 V / 112-136 V / 180-220 V / 208-252 V / 224-272 V, 50—440 Hz
Power	Max. 258 W
Weight	21.3 kg / 47 lb (instrument only)
Rear connectors	High speed Z Axis input (BNC connector, 60 Vp-p, 75 MHz) High sensitivity Z Axis input (BNC connector, 2 Vp-p, 10 MHz) Two LEMO S-series connectors for probe power Amphenol 165-16 connector (J1075) for remote control (single sweep ready/reset signals)

Internals

Like other 75xx and 76xx mainframes and the 7504, the 7503 has a linear power supply, as opposed to the switchmode supplies used in the later 4-slot mainframes.

Pictures

• 

  Front

• 

  Plug-in bay

• 

  Plug-in connectors missing sides

• 

  Horizontal amp on top

• 

  Vertical amp on the side

• 

  Left view, delay cable, CRT

• 

  Left view, power supply

• 

  Right view, mains frequency transformer

• 

  Readout board

• 

  Right side connector panel

• 

  Rear

• 
• 
•