11A32

Manuals – Specifications – Links – Pictures

The Tektronix 11A32 is a 400 MHz dual-channel amplifier plug-in for 11000-series scopes.

Key Specifications

Bandwidth	DC to 400 MHz; 100 MHz and 20 MHz BWL filters
Rise time	875 ps in 1 GHz mainframes such as the 11402, 11402A, 11403, 11403A, DSA601A, or DSA602A
Deflection	1 mV to 10 V per division in 1% calibrated steps
Input impedance	50 Ω or 1 MΩ
Features	High-resolution calibrated DC offset Fast overdrive recovery 5 VRMS overload protection in 50 Ω mode, with manual reset

Internals

Analog

Each input channel has a separate attenuator module containing an M474 buffer amplifier. The attenuator output feeds an M377 amplifier IC, one per input channel.

The display outputs of the two M377s are hard-wired in parallel and drive the mainframe’s 50 Ω input impedance. The same is true of the trigger outputs of the two amplifiers. The version of the M377 used in the 11A32 has 100 Ω output impedance so that two of them in parallel create a source impedance of 50 Ω.

Each M377 amplifier's nominal common-mode output voltage is zero whether enabled or not.

When not enabled, each M377 differential output is exactly zero by design. This fact is used during calibration by the plugin’s firmware to determine the mainframe’s imbalance and compensate for it during normal operation.

See also the block diagram below.

Digital

The 11A32 and the 11A34 use exactly the same firmware.

The 11A32 and 11A34 were originally intended to use Intel 8052 microcontrollers. However, during development, the firmware swelled beyond that chip's 8192-byte maximum on-chip ROM size. Doug Haines found an alternate supplier of 8051-compatible chips (OKI Semiconductor) that offered a 16Kbyte on-chip ROM, and that's what the plug-ins wound up with. The finished code size wound up at about 14 KB.

The 11A32 also contains a DS1120 NVRAM and an ACVS module that generates the analog control voltages needed for gain/offset control etc.

Links

• 11A-series plug-in NVRAM replacement
• Tek 11A32 @ barrytech.com

Pictures

• 
• 
• 

  Block diagram

• 

  11A32 Main Board Schematic

• 

  11A32 Main Interface

• 

  left side internal

• 

  right side internal

Custom ICs used in the 11A32