WR501

The Tektronix WR501 is a 16-channel word recognizer plug-in for the TM500 system.

Tektronix WR501
16-channel word recognizer Tektronix WR501 Produced from 1976 to (?) Manuals WR501 Service Manual (OCR) Article about WR501 and LA501 in Tekscope Magazine, 1976, Vol 8, No 2 Catalog Descriptions of DD501, DL502, and WR501 (All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

Key Specifications

please add

The WR 501 word recognizer takes, as its inputs:

16 digital input signals (through two P6451 probes)
specification of the 16-bit trigger word, including any don't-care bits

It produces a pulse at its output when the trigger word is recognized.

Links

Documents Referencing WR501

Document	Class	Title	Authors	Year	Links
Tekscope 1976 V8 N2.pdf	Article	A Plug-in Word Recognizer with Digital Delay	Pete Janowitz	1976	WR501 • LA501 • LA501W
070-2088-04.pdf	Book	TM500 Series Rear Interface Data Book		1985	AA501 • AF501 • AM501 • AM502 • AM503 • AM511 • DC501 • DC502 • DC503 • DC503A • DC504 • DC505 • DC505A • DC508 • DC508A • DC509 • DC510 • DC5009 • DC5010 • DD501 • DL502 • DM501 • DM501A • DM502 • DM502A • DM505 • DM5010 • FG501 • FG501A • FG502 • FG503 • FG504 • FG507 • FG5010 • LA501 • LA501W • WR501 • MR501 • PG501 • PG502 • PG505 • PG506 • PG507 • PG508 • PS501 • PS502 • PS503 • PS503A • PS505 • PS5010 • RG501 • SC501 • SC502 • SC503 • SC504 • SG502 • SG503 • SG504 • SG505 • SW503 • TG501 • TR501 • TR502 • MI5010 • MX5010 • SI5010

Internals

Most of the logic in the WR 501 is ECL, and is rated to operate up to about 50 MHz. It has synchronous (clocked) and asynchronous (unclocked) modes.

The WR 501 includes a delay function and can provide a trigger signal for an oscilloscope or provide a trigger signal and data acquisition for the LA501 Logic Analyzer.

Note that DL15 and DL115, the 24-pin delay lines that fit in the sockets on each board are only found on units that were interconnected to an LA 501. The empty socket for DL15 is visible in the pictures below, on the A1 daughter board. The socket for DL115 is on the board underneath A1, on the A2 main board. They are unnecessary if you are using the WR501 to trigger a scope.

These ECL delay lines, P/N 119-0775-00, 10 ns, 100 Ω, can be found in the 7D01 logic analyzer plugin for the 7000-series scopes.

Pictures

Front
Left internal
Left internal
Right internal
Logic pod connector
Block diagram