FG501A

Manuals – Specifications – Links – Pictures

The Tektronix FG501A is a function generator plug-in for the TM500 system.

The FG501A replaced the FG501 (1972) in 1981.

Key Specifications

Frequency	0.002 Hz to 2 MHz in eight decade steps
Output	Max. 30 Vp-p (into high impedance)
Attenuator	60 dB in 20 dB steps, 20 dB variable
Rise time	25 ns
Features	symmetry variable from 5 to 95%
Signals	sine, square, triangle, ramp, pulse
Features	voltage controlled frequency input (1000:1 ratio) triggering gated output with variable phase control

The TRIG OUT signal is available on the front panel via a BSM female connector.

The Phase control is effective in gated mode to control the starting phase of the generated waveform.

Differences to FG501

The FG501 non-A frequency maximum is 1 MHz, while the "A" model is specified at 2 MHz.

The FG501 features seven different functions – sine, triangle, square, positive- and negative-going ramps, pulse ≤50% duty, and pulse ≥50%. The duration of ramp and pulse waveforms is always equal to the half-cycle time of the sine, square, or triangle waveform frequency.

The FG501A model provides only three functions – sine, triangle, and square. However, it has an added variable symmetry control, effectively allowing the same functionality as the non-A model.

The FG501A also adds an output attenuator and increases the maximum open-circuit output voltage to 30 V from the FG501's 10/15 V.

Links

• FG507 - same specs as FG501A, added internal sweep generator
• Zenwizard Studios - Tektronix FG501A Repair and Calibration/Alignment

Documents Referencing FG501A

Patents that may apply to FG501A

Rear Interface

• Output: 28A (Common 27A)
• Trigger Output: 27B (Common 28B)
• Gate/Trigger Input: 24B (Common 25B)
• VCF Input: 21B (Common 22B)

Pictures

• 
• 
• 

  right interior

• 

  left interior

• 
• 

  right interior

• 

  left interior

• 

  rear connector

Components

Some Parts Used in the FG501A

(no results)