User:Peter: Difference between revisions
No edit summary |
No edit summary |
||
Line 15: | Line 15: | ||
Tek-sc504-am503.jpg | [[SC504]] | Tek-sc504-am503.jpg | [[SC504]] | ||
</gallery> | </gallery> | ||
===Other Instruments=== | ===Other Instruments=== | ||
<gallery> | <gallery> | ||
308-timing.jpg | [[308]] | 308-timing.jpg | [[308]] | ||
TM503 open1.jpg | [[TM503]] | TM503 open1.jpg | [[TM503]] | ||
TM504 front.jpg | [[TM504]] | |||
</gallery> | |||
===Carts, Cameras etc.=== | |||
<gallery> | |||
K202.jpg | [[202]] | |||
K205 7623 7613.jpg | [[205]] | K205 7623 7613.jpg | [[205]] | ||
C-5.jpg | [[C-5]] | |||
C-52.jpg | [[C-53]] | |||
</gallery> | </gallery> | ||
===Plugins=== | ===Plugins=== | ||
====500==== | |||
<gallery> | <gallery> | ||
1A1.jpg | [[1A1]] | 1A1.jpg | [[1A1]] | ||
Line 29: | Line 39: | ||
81.jpg | [[81]] | 81.jpg | [[81]] | ||
Tek_82_early_front.jpg | [[82]] | Tek_82_early_front.jpg | [[82]] | ||
</gallery> | |||
====7000==== | |||
<gallery> | |||
Tek-7a11-front.jpg | [[7A11]] | Tek-7a11-front.jpg | [[7A11]] | ||
Tek 7a13 front.jpg | [[7A13]] | Tek 7a13 front.jpg | [[7A13]] | ||
Line 61: | Line 74: | ||
Tek-7s14-front.jpg | [[7S14]] | Tek-7s14-front.jpg | [[7S14]] | ||
Tek-7m11-front.jpg | [[7M11]] | |||
Tek-7m13-front.jpg | [[7M13]] | |||
Tek-7ct1n-front.jpg | [[7CT1N]] | |||
</gallery> | |||
====S==== | |||
<gallery> | |||
Tek-s-4.jpg | [[S-4]] | Tek-s-4.jpg | [[S-4]] | ||
Tek-s6-front.jpg | [[S-6]] | Tek-s6-front.jpg | [[S-6]] | ||
Tek-s52-front.jpg | [[S-52]] | Tek-s52-front.jpg | [[S-52]] | ||
Tek-s53.jpg | [[S-53]] | Tek-s53.jpg | [[S-53]] | ||
</gallery> | |||
====TM500==== | |||
<gallery> | |||
Am503 front.jpg | [[AM503]] | Am503 front.jpg | [[AM503]] | ||
Ps503a-front.jpg | [[PS503A]] | Ps503a-front.jpg | [[PS503A]] | ||
Tek-sc504-am503.jpg | [[SC504]] | |||
</gallery> | </gallery> | ||
Revision as of 05:28, 8 May 2019
Scopes
Other Instruments
Carts, Cameras etc.
Plugins
500
7000
S
TM500
Probes and other gear
-
P6451 probe internal, PCB front
-
P6451 probe internal, PCB back
Screen shots
-
Faster-than-light beam on 7104? Using a 067-0587-02 calibration fixture at maximum amplitude produces this trace spanning 1.2 Div horizontally at 200 ps/Div and 8 Div vertically. Trace length is (1.2² + 8²)½ × 8.5 mm = 68.8 mm, travelled in 1.2 × 200 ps = 240 ps. Apparent speed is therefore 68.8×10-3 / 240×10-12 m/s or 2.86×108 m/s. Very near miss ...
-
7104 rise time measurement. 150 ps risetime pulse from 067-0587-02 at 100 Hz repetition rate. Measured 240 ps (corrected for 150 ps fixture rise time: 190 ns = 1.8 GHz)
-
7104 rise time measurement as before, 1000 Hz repetition rate at same brightness settings.
-
7104 recording a single shot pulse (from 067-0587-02) at 200 ps/Div. Camera: Nikon D7000, 50 mm f/1.4, ISO 3200, 1/2 s. CRT filter not removed.
-
7104 recording 1 GHz sine, single shot at 500 ps/Div. Camera: Nikon D7000, 50 mm f/1.4, ISO 3200, 1/2 s. CRT filter not removed. CRT amplification loss is evident around the center line.
-
BC337 on 7CT1N
-
P6230 Rise time without ground lead: 9.2 * 20 ps = 184 ps (equiv. to 1.9 GHz bandwidth)
-
P6230 Rise time - Effect of using the "low inductance" ground lead - rise time 400 ps, bandwidth 875 MHz
-
P6230 Rise time - Using the 250 mm alligator ground lead - severe pulse distortion, rise time ~3 ns (115 MHz)!
-
Classic readout board diagnostic display
-
Tektronix 067-0587-02, gain mode, in horizontal slot
-
Tektronix 067-0587-02, gain mode, in vertical slot
-
7B85 used for rise time measurement
-
7B85 used for rise time measurement
-
7B85 used for pulse width measurement
-
7B85 used for pulse period measurement
-
7B85 used for pulse period measurement
-
7S12 as a sampler displaying a 1 GHz signal (hi-res mode / storage)
-
7S12 as a sampler displaying a 1 GHz signal (hi-res mode / storage)
-
7S12 as a sampler displaying a 1 GHz signal (normal mode / non-storage)
-
7S12 displaying the incident pulse from an S-52 (nom. < 25 ps) through an S-6 head (nom. < 30 ps)
-
sub-millivolt triangle signal displayed through 7A22, BW=1 kHz
-
sub-millivolt triangle signal displayed through 7A22, BW=10 kHz
-
sub-millivolt triangle signal displayed through 7A22, BW=100 kHz
-
sub-millivolt triangle signal through 7A22, BW=1 MHz
-
Measuring diode reverse recovery
-
BAT41 diode reverse recovery, 20 mA/Div
-
Tunnel diode quick check example using the method from Service Scope 49. Right beam is zoomed with delayed timebase to show step speed.
-
308 display, timing mode (binary counter example)
-
308 display, state mode (binary counter example)